General Announcements

[Celwin]

I thought they recommended UHU POR glue. I can't find any locally, so I was going to try normal contact adhesive which sounds much the same. I'm also keen on trying a thin smear of polyurethane but it will need clamping somehow, as this glue expands before setting.
CA would be difficult on such a long line. If you're using el-cheapo tubes, you're bound to run out half way through a run with the first bit drying before you break onto the new tube and get it down...

I almost managed to drop off the templates for the 130% version on Sunday. Too much on, so sacrifices needed to be made... I'll try to drop them off on Wednesday. I have some pylon lights to test to see if they're visible too. Not finished yet, but should be good for our own local racing.