"SPAD" Simple Plastic Aircraft Design

[KENNYGLIDE]

Just thinking ...we make a complete set of templates first up from 3mm corflute. Then it will be easy to trace around the pieces for the other models rather than working with paper and depron ...we would then have permanent templates to make bits as required after crashes ect. Alternatively we could make the templates out of MDF but would be more difficult to cut . We could start on Sunday..morning ...I will be flying Sunday arvo....i will supply a sheet of 3mm to get started...will need some sharp knives and marking pens . Will need at least 3 people to start with Stanley knives and some good scissors....probably need cutting boards of some sort...MDF sheets or similar....